The Blaster SS is an E-core style coil, which is a very efficient design when it comes to producing high voltage and spark energy. The windings produce 300mA and can handle up to 48,000 volts when used with an MSD 6 Series Ignition Control. The windings are held secure in a Dupont® Rynite™ injection molded shell and are then encased in an epoxy compound for protection against vibration and water. The primary terminals are located at opposite ends of the tall spark tower so there is no chance of arcing especially with the high dielectric characteristics of the Rynite housing.
The Coil is compact enough to fit in tight areas and is supplied with vibrations mounts.
FEATURES
-Improved output coil for electronic ignitions, and MSD Ignitions
-Efficient winding design and assembly creates a compact housing
-Primary and secondary windings are encased in Ciba polyurethane
-70:1 turns ratio and lower primary resistance produce high voltage output
-Dupont Rynite housing with a tall tower and brass primary terminals
-CARB E.O. Approved
BLASTER SS COIL SPECIFICATIONS
Primary Resistance: .355 ohms
Peak Current: 300mA
Secondary Resistance: 6.2K ohms
Spark Duration: 180uS
Maximum Voltage: 48,000 volts
Primary Inductance:
6mH
Turns Ratio:
70:1 Tested with an MSD 6AL
measured at plug gap. |
